English (US)
Language Chooser
English (US)
Deutsch (DE)
Search
Search titles only
By:
Search titles only
By:
Home
Forum
F.A.Q.
Media
Resources
Log in
Register
English (US)
Language Chooser
English (US)
Deutsch (DE)
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
Reply to thread
Home
Forum
iFactory3D One
Assembly and Construction
Assembly general discussion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="goregut" data-source="post: 173" data-attributes="member: 73"><p>Thank you for posting this! I had/have all these issues as well. I should have wrote them all down and kept track of them. My current major issue is</p><p></p><p>I couldn't tell which version of the fw it was and the octoprint instance didn't have the filiment sensor plugin installed. So I went to install the fw update. The filament sensor was already plugged into the pi, but I still unplugged it like the update instructions said. Now whenever I turn the printer on Marlin throws the "Outage Recovery Printer Halted Please Reset". I can't get past this screen. Email iFactory and posting here as well.</p><p></p><p>Update: Didn't notice the github link in the firmware section of the forums before. I pulled that down and compiled. Updated, and back in business.</p></blockquote><p></p>
[QUOTE="goregut, post: 173, member: 73"] Thank you for posting this! I had/have all these issues as well. I should have wrote them all down and kept track of them. My current major issue is I couldn't tell which version of the fw it was and the octoprint instance didn't have the filiment sensor plugin installed. So I went to install the fw update. The filament sensor was already plugged into the pi, but I still unplugged it like the update instructions said. Now whenever I turn the printer on Marlin throws the "Outage Recovery Printer Halted Please Reset". I can't get past this screen. Email iFactory and posting here as well. Update: Didn't notice the github link in the firmware section of the forums before. I pulled that down and compiled. Updated, and back in business. [/QUOTE]
Name
Verification
Post reply
Home
Forum
iFactory3D One
Assembly and Construction
Assembly general discussion
Top
Bottom
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
